Kyoeisha Baroness LM1808, Owner'S Handling Manual

Page: 7 / 44

1）Start
① Open the fuel cock, which is under the fuel tank.
② Move the throttle lever from the low-speed side slightly to the high-speed side.
③ Pull the choke button. Pull the button halfway for restarting, as necessary.
④ Pull the start rope hard.
⑤ After the engine has started, slowly return the choke button.
⑥ Warm up the engine at a slow speed for 1-2 minutes without a load.
⑦ Gradually move the throttle lever to high-speed side.
2）Stop
① Move the throttle lever to the slow-speed, and continue idling for 1-2 minutes.
② Turn off the engine switch.
③ Close the fuel cock.
3-3. Inspection of Fuel
3-4. Inspection of Oil Leakage
3-5. Inspection of Tires
3-6. Inspection of Belts
When fuel is insufficient, supply lead-free gasoline for automobiles.
The tank capacity is approx. 6 litres.
Check the bottom of the machine for oil leakage.
The mowing height changes according to the pneumatic pressure of the tire.
Keep the pneumatic pressure constant at all times.
Excessive belt tension will damage bearings or break shafts. If belts are
excessively loose, slippage and belt damage will result, or the reel rotation
and operation speed will not be high enough for mowing. Check the belt for
appropriate tension and make sure that there is no crack.
（Fig.4）
Size of tire Pneumatic pressure
Front wheel 4.00-5 2.0 kg ／cm 2
Rear wheel 18x8.50-8 0.8 kg ／cm 2
3-7. Inspection of Mowers
4-1. Start / Stop of Engine
Belts are installed as shown in Fig.4. (6 types; 8 in total)
For adjustment of belts, refer to 4-11 Adjustment of Belt Tension.
Check the three mower units for the mowing height and sharpness of blades.
For details, refer to the engine Handling manual.
4. Operation and Adjustment of Each Section
Brake pedal
V-belt
V-belt
V-belt
V-belt
V-belt
V-belt
V-belt
(b) Clutch lever for
left/right mowers
Engine
Differential lock pedal
(a) Traveling
clutch lever
Change lever
(c) Clutch lever for rear mower
- 5 -