Kyoeisha Baroness LM1808, Owner'S Handling Manual

Page: 11 / 44

2) Procedure
For details, see the Handling Manual of Lapping Machine.
① Bring the blade reel cylinder and the bottom blade into
slight contact with each other uniformly at right and left. Cut newspaper
into strips and check which portion of the blade is dull.
② Connect the lapping machine and the blade reel cylinder shaft of the mower.
③ Rotate the blade reel cylinder in the direction opposite to the mowing
direction and apply the abrasive with a brush to the portion where the
newspaper was cut well.
④ Idle the machine for a while, and then switch off the lapping machine
when contact noise is no longer heard.
⑤ Trially cut the newspaper strips with the entire width of the blade reel
cylinder, and note portions of cutting well and not well.
◆ Repeat the above steps ①〜⑤ When the blade reel cylinder and bottom
blade are uniformly engaged (brought into contact) with each other
entirely, wash off the abrasive to finish the work.
◆The edges are very sharp. Be sure to wear gloves when touching the blades.
◆The blade reel cylinder must be rotated in the direction
opposite to the mowing direction.
◆It is dangerous when you apply the abrasive with a brush to the rotating
blade reel cylinder. Be careful that your hand and brush will not be caught.
◆When cutting the newspaper, pay attention to your fingers that will turn
the blade reel cylinder.
◆Should the abrasive enter your eyes, immediately wash your eyes with
water. If the condition is serious, consult a doctor.
For details, see the Handling Manual for Engine.
Periodically clean the air cleaner so that clean air can be supplied to the
engine.
① Clean the urethane foam with white kerosene, and then immerse it in a
mixture of three parts white kerosene and one part engine oil, and firmly
squeeze before installing.
② Clean the element with white kerosene, immerse it in the mixture of three
parts white kerosene and one part engine oil, and then shake/squeeze it
before installing.
DANGER
7. Maintenance and Inspection of Portions
Before checking, clean the machine body. The parts of operating portions
and consumables should be periodically maintained and replaced as
necessary.
For details, see the Handling Manual for Engine.
If the engine oil is contaminated or running short or if poor-quality oil is
used, the life of the engine will be extremely shortened. For changing oil,
drain the oil through the drain plug when the engine is stopped and warm.
7-1 Change of Engine Oil
First time after 20-hour operation
Second time and later every 50-hour operation
Oil quantity approx. 1.2 litres
SAE viscosity SAE30 in summer, SAE20 in winter
7-2 Cleaning of Air Cleaner
Drain plug
Oil filling port
(Fig. 14)
- 9 -