2L6/2N6/2N5/2N4-3
1-4-63
(2) Self diagnostic codes
If the part causing the problem was not supplied, use the unit including the part for replacement
Caution:
Before attempting to check the power supply, fuser unit, and the IH controller PWB, be sure to turn the power
switch off and unplug the machine from power. Allow at least 5 seconds before starting to conduct service until
the capacitors on the circuit boards have been completely discharged.
To reset a service call regarding the Maintenance T display and the DP, performing U906 Disconnection at
Defect is required. (See page 1-3-224)
.
Code
Contents
Related parts
Check procedures/
corrective measures
0030
FAX control PWB system
error
Processing with the fax soft-
ware was disabled due to a
software problem.
FAX control PWB
1. Turn the main power swtch off and after
5 seconds, re-mount the FAX controller
PWB, then turn power on.
2. Reinstall the fax software.
3. Replace the FAX control PWB.
0070
FAX control PWB incompat-
ible detection error
Abnormal detection of FAX
control PWB incompatibility In
the initial communication with
the FAX control PWB, any
normal communication com-
mand is not transmitted.
FAX control PWB
(The FAX PWB
installed will not be
the one designed
for the machine.)
1. Install the FAX system designed for the
model.
2. Reinstall the fax software.
0080
Option printing system
device error.
The version of the FPGA for
Fiery control is not readable.
(Defective FPGA)
Defective FPGA for
printing system
control.
1. Turn the main power swtch off and after
5 seconds, then turn power on.
2. Replace the main PWB (see page 1-5-
72).
0100
Backup memory device
error
EEPROM(main
PWB)
1. Turn the main power swtch off and after
5 seconds, then turn power on.
2. Check that the EEPROM on the main
circuit PWB is peroperly installed on the
main circuit PWB and, if not, re-install it.
3. Replace the main PWB (see page 1-5-
72).
0120
MAC address data error
For data in which the MAC
address is invalid.
EEPROM(main
PWB)
1. Turn the main power swtch off and after
5 seconds, then turn power on.
2. Check the MAC address on the network
status page.
3. If it is blank, obtain an EEPROM with its
MAC address written from the service
support and install.
4. Replace the main PWB (see page 1-5-
72).
Summary of Contents for TASKalfa 3051ci
