Kyocera TASKalfa 180, Operation Manual

Page: 47 / 164

Preparation before Use
OPERATION GUIDE 2-15
2
How to Load Originals
IMPORTANT: Before loading originals, be sure that there are no originals left on the original eject table.
Originals left on the original eject table may cause the new originals to jam.
1
Adjust the original width guides to fit the originals.
NOTE:
Before setting originals, make sure that there
are no originals remaining on the original eject table.
Originals left on the eject table may cause other
originals to jam.
When setting multiple originals at one time, be sure to
use originals of the same size. It is, possible, however
to use different size originals of the same width (for
example, 11 x 17" (Ledger) and 11 x 8
1/2
" or A4 and
A3 at the same time in the auto selection mode. Refer
to
Chapter 4 Auto Selection Mode .)
2
Arrange the originals in order and set them face up
(front side up for 2-sided originals) on the original
table.
IMPORTANT: Be sure to set only a number of originals
that does not exceed the level indicator located inside
the rear original insert guide. If you set originals
exceeding the specified number, the originals may jam.