Kyocera DP-750, Service Manual

Page: 58 / 124

3LL/3LK-2
1-3-38
U411
Adjusting the scanner automatically
Description
Uses a specified original and automatically adjusts the following items in the scanner and the DP scanning
sections.
Purpose
To perform automatic adjustment of various items in the scanner and the DP scanning sections.
Method
1. Press the start key.
2. Select the item. The screen for executing is displayed.
*: Dual scan DP only.
Method: [SCANNER]
1. Enter the target values which are shown on the specified original (P/N: 302FZ56990) executing mainte-
nance item U425.
2. Set a specified original (P/N: 302FZ56990) on the platen.
3. Select the item.
4. Press the start key. Auto adjustment starts.
When automatic adjustment has normally completed, [Complete] is displayed. If a problem occurs dur-
ing auto adjustment, [ERROR XX] (XX is replaced by an error code) is displayed and operation stops.
Should this happen, determine the details of the problem and either repeat the procedure from the
beginning, or adjust the remaining items manually by running the corresponding maintenance items.
Maintenance
item No.
Description
Display Description Original to be used for
adjustment (P/N)
SCANNER Automatic adjustment in the scanner section 302FZ56990
DP(FACE UP) Automatic adjustment in the DP scanning
section (first page) 302AC68243
DP(FACE DOWN)* Automatic adjustment in the DP scanning
section (second page)
302AC68243/303JX57010/
303JX57020
Display Description
ALL Automatic adjustment using the platen for: original size magnification/
leading edge timing/center line, input gamma, chromatic aberration filter,
MTF filter and matrix.
INPUT Automatic adjustment using the platen for: original size magnification/
leading edge timing/center line.
C.A. Automatic adjustment using the platen for: chromatic aberration filter.
MTF Automatic adjustment using the platen for: MTF filter.
GAMMA Automatic adjustment using the platen for: input gamma.
MATRIX Automatic adjustment using the platen for: matrix.