Kyocera Mita KM-2030, Instruction Handbook Manual

Page: 51 / 74

CHAPTER 6 COPIER MANAGEMENT
Machine default setting
0
SHUT-OFF TIME
!
DISPLAY CON-
TRAST ADJUST.
@
MANAGEMENT
CODE CHANGE
#
SILENT MODE
$
AUTO DRAWER
SWITCH
%
COUNTER
REPORT
Content of machine default setting
Selects a certain length of time from when the copier is not used to
when the auto shut-off function (page 4-7) switches off the power
automatically. The auto shut off function can be turned off as well. This
setting cannot be used in that case (“
2
AUTO SHUT-OFF”).
The initial setting is 30 minutes.
• It is recommended to prolong time interval that triggers the auto shut-
off if the copier is used frequently, whereas shorten it if it is not used
frequently.
• See “
2
AUTO SHUT-OFF” to release the auto shut-off function.
Changes the display contrast when the message display is not seen
clearly.
Changes the management code that accesses the management mode
(page 6-1) and management mode in this default setting (page 6-9).
• If management code is changed, keep a note of the new one.
The copier can be switched to the silent mode, which stops the motor
inside the copy machine immediately after copying has been finished.
When “ON” is selected, the motor stops immediately after copying has
been finished.
Selects whether the automatic drawer switching function (page 2-4) is
used or not.
Prints the toner counter report.
Setting range
15 to 240 MIN.
(5-minute incre-
ments)
1 to 7
– – – –
ON/OFF
ON/OFF
———————
Default setting
30 MIN.
4 (center)
2000
OFF
ON
—————
Page
6-18
6-18
6-18
6-18
6-19
6-19
6-15