Kyocera Mita FS-1050, Operation Manual

Page: 12 / 209

Understanding the Operator Panel
1-2
1.1 Understanding the Operator Panel
The operator panel has an LCD message display, 3 LED indicators, and
eight keys.
Message Display
The message display gives information in the form of short messages. The
eight messages listed below are displayed during normal warm-up and
printing.
Other messages, those needing operator attention, are explained in
Chapter 4
Chapter 4 Chapter 4
Chapter 4
.
Interface Indicator
The LCD message display also shows the interface that is currently used in
the form of the following abbreviations:
PAR
Standard bi-directional parallel interface
USB
Standard USB interface
SER
Optional serial interface (RS-232C)
OPT
Optional network interface card
---
No interface is active.
Message
Message Message
Message Meaning
Meaning Meaning
Meaning
Self test
The printer is self-testing after power-up.
Please wait
The printer is warming up and is not ready.
Ready
The printer is ready to print.
Processing
The printer is receiving data, generating graphics,
reading a memory card or printing. When the
printer is switched on for the first time after the
toner container is installed,
(Adding toner)
also
appears.
Sleeping
The printer is in Sleep mode. The printer wakes
from Sleep mode whenever
GO key on the operator
panel is pressed, the cover is opened or closed, or
data is received. The printer then warms up and
goes online. The time that the printer takes to enter
Sleep mode depends on the Sleep Timer setting.
Cancelling data
Jobs inside the printer are being cancelled. To
cancel a job, see the table on page 1-5 1-5 1-5 1-5 .
Waiting
The printer is waiting for the end-of-job command
before printing the last page. Pressing the
GO key
allows you to obtain the last page immediately.
FormFeed TimeOut
The printer is printing the last page after a waiting
period.