37
MAINTENANCE
Battery removal & installation
The battery
1
is in the battery box under the floor board mat
2
.
NOTE: Always keep ignition switch OFF when servicing
the battery.
Fuses
When frequent fuse failures occur, it usually indicates a short
circuit or an overload in the electrical system.
NOTE: See your KYMCO dealer for electrical system
diagnosis and repair.
Never use a fuse with a different rating from that speci-
fied. Serious damage to the electrical system or a fire
hazard may result, causing a dangerous loss of lights
or engine power.
1. When removing the battery for charging or replacement, dis-
connect the negative (-) terminal lead from the battery first,
then disconnect the positive (+) terminal lead.
2. When installing the battery, connect the positive terminal
lead (+) first, then the negative terminal lead (-).
1. Open the fuse holder
3
.
Pull the fuse holder clips
4
out of the holder.
2. Slide the fuse
5
out of
the holder clips.
3. Install a new fuse
6
of
the proper specification
into the holder clips.
4. Press the fuse and the
holder clips
4
back into
the holder.
5. Close the fuse holder
3
and set it back in place.
3
3
3
3
3
3
3
3
3
3
4
4
4
4
4
6
6
6
6
6
6
6
6
6
6
4
4
4
4
4
1
1
1
1
1
2
2
2
2
2
Fuse replacement
FUSE SIZES: 7A, 10A, 10A