KYMCO MXU 450i, Service Manual, Page: 106 / 172

6-15
6
KC285
9. Place a drain pan under the ATV to contain any oil
leakage; then using a slide hammer, remove the
drive axle.
KC286
REMOVING FRONT DRIVE AXLE
„
NOTE: For removing a front drive axle, see Front
Differential in this section.
CLEANING AND INSPECTING
„
NOTE: Always clean and inspect the drive axle
components to determine if any service or replace-
ment is necessary.
1. Using a clean towel, wipe away any oil or grease
from the axle components.
CD019
2. Inspect boots for any tears, cracks, or deteriora-
tion.
„
NOTE: If a boot is damaged in any way, it must be
replaced with a boot kit.
3. Inspect the gear case seals for nicks or damage.
DISASSEMBLING AXLES
1. Using a side-cutters (or suitable substitute),
remove the large clamp from the boot.
CD020
2. Wipe away excess grease to access the retaining
ring. Using an awl, remove the circlip.
CD021
3. Using a snap ring pliers, remove the snap ring
securing the bearing ring to the shaft. Note the
direction of the bearing for assembling purposes.
CD023
4. Note the difference inside each bearing ring end
for assembling purposes; then remove the bearing
ring.