82
After storage, your ATV requires particular attention and adjust-
ments to make sure you will enjoy many miles of trouble-free riding.
To take your ATV out of storage, KYMCO recommends using the
following procedure:
1. Clean your ATV thoroughly
2. Clean the engine. Remove the cloth from the exhaust system
outlet
3. Check all control wires and cables for signs of wear or fray-
ing. Replace any suspect items
4. Change the engine/transmission oil and filter
5. Charge the battery and test the voltage (refer to page 73)
before installation. When installing the battery, connect the
positive cable first
GENERAL MAINTENANCE
PREPARATION OF YOUR ATV FOR RIDING AFTER STORAGE
6. Inspect the front and rear brake systems. Verify the good condi-
tion of the brake fluid, pads and the controls -
7. Verify the proper operation and adjustment of all controls, head-
lights, taillight, brakelight, and the headlight aim - adjust or re-
place items as necessary
8. Check the tire pressures - inflate the tires to the recommended
pressure
Before installing the battery, make sure the ignition
switch is in the OFF position. Connect the positive
cable to the battery first.
9. Tighten all nuts, bolts, cap screws, and screws - tighten
these fasteners to the proper torque specification. Make sure
that the rivets holding components together are tight - re-
place any loose rivets
10. Make sure the steering moves freely and does not bind
11. Check the spark plug - clean or replace as necessary
12. Follow the recommendations listed in the Pre-Ride Inspection
