81
KYMCO recommends the procedures listed on this page to pre-
pare your ATV for storage. If you lack the technical ability to pre-
pare your ATV for storage, consult an authorized KYMCO ATV
dealer about performing this service.
6. Plug the exhaust system outlet with a clean cloth
7. Apply some light oil to the upper steering post bushing and
shafts of the shock absorbers
8. Tighten all nuts, bolts, cap screws, and screws - tighten
these fasteners to the proper torque specification. Make sure
that the rivets holding components together are tight - re-
place all loose rivets
9. Disconnect the battery cables (negative cable first) and then
remove the battery. Clean the battery posts and cables.
Store the battery in a clean, dry area were you can access
it for periodic charging
10. Store your ATV indoors, parked in a level position
1. Clean the seat cushion (cover and base) with a damp cloth
and allow to the seat’s surface to dry
2. Clean your ATV thoroughly by washing dirt, oil, grass, and
other debris from the entire vehicle. Allow the ATV to dry thor-
oughly. DO NOT get water into the engine, air intake or ex-
haust
3. Drain the gas tank completely or add a fuel stabilizer to the
fuel in the gas tank. Remove the air filter housing cover and
air filter
4. Start the engine and allow it to idle, then spray KYMCO En-
gine Preserver into the air filter opening for a period of ten to
twenty seconds. Turn off the engine and reinstall the air filter
and housing cover
GENERAL MAINTENANCE
PREPARATION FOR STORAGE
Prior to storing your ATV, it should be properly serviced
to prevent component rusting and deterioration.
If the interior of the air filter housing is dirty, clean it of any
debris before starting the ATV’s engine.
5. Drain the gasoline from the carburetor float bowl
Do not store your ATV outside in direct sunlight to
avoid damage to the body work. Avoid using a plas-
tic cover as moisture can condense on the ATV, caus-
ing rust and corrosion.
