KYMCO Kymco UXV 500i, Service Manual

Page: 413 / 426

22. FUEL INJECTION SYSTEM
22-28
UXV 500i
Apply oil onto a new O-ring.
When install the T-MAP sensor onto the
throttle body, being careful not to damage
the O-ring.
Install the set plate and tighten the screw
securely.
Apply oil onto a new O-ring.
When install the ISC and T-MAP sensor
onto the throttle body, being careful not to
damage the O-ring.
DIAGNOSTIC TOOL
CONNECTOR
INSPECTION
Unhook the hood and then slowly tilt
hood up until it .
Make sure moving the shift lever into the
N or P position .
Remove diagnostic tool connector protect
sheath.
Turn the ignition switch to “ON”
Measure the voltage between the following
terminals of the diagnostic tool connector .
Terminal Normal
BR/L (+) G/B (-) Battery voltage
B/L (+) W/L (-)
Battery voltage
－
1 V
T-MAP sensor
O-ring
Always replace an O-ring with a new one.
＊
Screws ISC
Screw T-MAP sensor
Diagnostic Connector
Diagnostic Connector
Protect
sheath.
Hood