KYMCO K-XCT 300i, Owner'S Manual, Page: 564 / 656

13. Electrical Systems K- XCT 300i
13 ‐ 2
• Do not disconnect and soon reconnect the power of any electrical equipment because
the electronic parts in the regulator/rectifier will be damaged. Turn off the ignition
switch before operation.
• It is not necessary to check the MF battery electrolyte or fill with distilled water.
• Check the load of the whole charging system.
• Do not quick charge the battery. Quick charging should only be done in an emergency.
• Remove the battery from the motorcycle for charging.
• When replacing the battery, do not use a traditional battery.
• When charging, check the voltage with an electric tester.
TROUBLESHOOTING
No power
• Dead battery
• Disconnected battery cable
• Fuse burned out
• Faulty ignition switch
Intermittent power
• Loose battery cable connection
• Loose charging system connection
• Loose connection or short circuit in the ignition system
Low power
• Weak battery
• Loose battery connection
• Charging system failure
• Faulty regulator/rectifier
Charging system failure
• Loose, broken or shorted wire or connector
• Faulty regulator/rectifier
• Faulty A.C. generator