KYMCO K-XCT 300i, Owner'S Manual, Page: 440 / 656

8. Steering > Handlebar K- XCT 300i
8-20
Grips
If you plan to replace the grips you can slice them lengthwise with a razor blade and peel
them off. To remove the grips without cutting them use a screwdriver to open a gap
between the grip and the handlebar.
Spray in contact cleaner to break up the grip cement. Use compressed air to expand the
grip so it can be easily slid off the end of the handlebar. Note the relationship between
the angle of the grip and the throttle tube so that the new grip can be installed with the
correct angle.
NOTE: Always wear safety glasses when using compressed air and never point it directly
at yourself or anyone else.
Before installing the grips to either the throttle tube or the handlebar, wipe down the area
with a brake or parts cleaner that will dry without leaving a residue. When you are sure
the area is dry apply grip cement to the bar or tube. Install the left grip at an angle of your
preference. Install the throttle grip onto the tube with the same angle as the original grip.