This document is the property of KYMATI GmbH and must not be copied or disclosed without its written authorisation.
- KYMATI GmbH – 2021
KY.MAN.0164 (2.0)
KY-RAY 3D.03.01 User Manual
Doc.- No.: KY.MAN.0164
Version:
2.0
Date:
16.06.2021
Page:
28 of 36
Figure 19: Connect to a specific device
All devices are shipped with a preconfigured scenario which already allows first measurements
with the device. Please switch to the "Measurements” tab and verify that the “Current active
scenario is set to a number between 0 and 3. If this is not the case, please select a new active
“default” scenario from the dropdown list below and press the “Change Active Scenario”
Button. This operation requires a couple of seconds to complete.
To speed up the data transmission of points select “Enable Bulk Data Transfer” and press the
button “Get new Measurement”. The plot should then display the detected reflections. Purple
points indicate reflections of low signal to noise ratio whereas green or yellow points indicate
points with higher signal to noise ratio.
