This document is the property of KYMATI GmbH and must not be copied or disclosed without its written authorisation.
- KYMATI GmbH – 2021
KY.MAN.0164 (2.0)
KY-RAY 3D.03.01 User Manual
Doc.- No.: KY.MAN.0164
Version:
2.0
Date:
16.06.2021
Page:
27 of 36
First, start the KYMATI Primary Radar Quickstart software, choose the proper interface with
the IP “192.168.75.1” and press the button “1. Select Interface”. This will discover all connected
KYMATI devices. The status field should indicate how many devices were found during this
operation.
Figure 18: Discover devices using the Quickstart GUI
Next, choose the detected device from the dropdown list below and press “2. Select Device”.
Please check that the device is in “OperationMode.Application”. If this is not the case: use the
following procedure to switch it to application mode:
-
Choose “OperationMode.Application” from the dropdown list next to the button “Set
Default Bootmode”
-
Press the Button “Set Default Bootmode” to change the boot mode
-
Press the “Restart Device Button” and wait a couple of seconds for the device to reboot
until the Status LEDs are rotating again.
-
Start from the beginning by doing another discovery run and re-selecting the device.
