KYLAND Technology SICOM3000, Hardware Installation Manual

Page: 23 / 40

Connection
17
ƽ
How to Connect the SFP Optical Module
Figure 15 Connecting the SFP Optical Module
Insert the SFP optical module into the SFP slot in the switch, and
then insert the fibers into the TX port and RX port of the SFP module.
Identify the RX port and TX port of an SFP optical module:
1. Insert the two connectors in one end of two fibers into the SFP
module, and those in the other end into the peer module.
2. View the corresponding connection status LED:
If the LED is on, the connection is correct. If the LED is off, the link is
not connected. This may be caused by incorrect connection of the TX and
RX ports. In this case, swop the two connectors at one end of the fibers.
Optical fiber
SFP optical module
SFP slot
The device uses laser to transmit signals in fibers. The
laser meets the requirements of level 1 laser products.
Routine operation is not harmful to your eyes, but do not
look directly at the fiber port when the device is powered on.
If the defined transmission distance of an SFP module is longer
than 60km, do not use a short fiber (<20km) for connection. If
such a short fiber is used, the module will be burned.
Caution:
ƽ
ƽ