Mounting
7
KIEN1009-3S/M-6T is used as an example to show the dimensions and mounting modes. The
dimensions and mounting modes of other models are similar.
3.2 Mounting Modes and Steps
The series switches support DIN-rail and panel mounting. Before installation, make sure that the
following requirements are met.
1) Environment: temperature (see Table 1), ambient relative humidity (5% to 95%,
non-condensing)
2) Power requirement: The power input is within the voltage range of the switch.
3) Grounding resistance: <5
4) No direct sunlight, distant from heat source and areas with strong electromagnetic
interference.
3.2.1 DIN-Rail Mounting
Mounting
Step 1: Select the mounting position for the device and guarantee adequate space and heat
dissipation (dimensions: 53.6mm×135mm×106.5mm).
Step 2: Insert the connecting seat onto the top of the DIN rail, and push the bottom of the device
inward and upward to ensure the DIN rail fits in the connecting seat. Make sure the
device is firmly installed on the DIN rail, as shown in the following figure.
Figure 8 DIN-Rail Mounting
