7
8
6.User Code
6-1 The preset User Code is 1234. Please delete it and create your personal code
before using lockset for the first time.
6-2 Up to 6 sets of User codes can be saved.
6-3 User Code is only for activating the lock, without programming function.
6-4 User Code is 4-10 digits in length.
6-5 User Code can be deleted or changed anytime if needed.
7.Delete Individual User Code
7-1 User Codes can be deleted individually. You can reset the same number as code
after it has been deleted.
7-2 Programming code is required to delete individual User code.
8.Delete All User Codes At Once
8-1 All User Codes can be deleted at once. You can still reset the same numbers
as codes after they have been deleted.
8-2 Auto-locking and Keypad locking function will be invalid after deleting all
User Codes and the lock can only be operated by key. These functions will be
restored when recreate new User Codes.
8-3 You need to enter Programming Code to delete all User Codes.
9.Temporarily Disable All User Codes
9-1 Auto-locking and Keypad locking function will be invalid when User Codes are
temporarily disabled. The lock can only be operated by key during that time.
9-2 Repeat the programming steps again to restore the User Codes.
10.Create a Disposable User Code
10-1 Disposable User Code can be used only once.
10-2 You can reset the same number as Disposal User Code more than once.
10-3 Programming Code is required to create a Disposable User Code.
11.Restore Preset Factory Code
11-1 You can restore Preset Factory Code by pressing “R” button on the interior
receiver module when you forget Programming Code or you want to cancel all
previous settings.
11-2 After restoring factory settings, the Programming Code will be 0000; the
User Code will be 1234 again.
12.Unlock the door
The door can be unlocked by key or pressing User Code on keypad from outside or by
interior turn-piece.
13.Lock the door
The door can be locked by key or pressing Programming Button on keypad from
outside or by interior turn-piece.
14.Incomplete Door Closing / Opening
14-1
If the door cannot be closed completely either because of an obstruction or motor
failure, you will see button 1 flash in red 3 times and hear 3 beeps
(No alarm when it's in mute). You need to enter User Code to unlock the door for
remaining the bolt retracted, and press Programming Button to lock the door
again.
14-2 If the latch bolt gets stuck or can't extend/retract completely all the time, please
check if the strike aligns with the latch bolt perfectly and adjust the strike to
proper position if required. After long use of the door hinge, the latch bolt might
get stuck easily because the door is deformed or lopsided.
15.To Activate / Deactivate Auto-Locking Function
15-1
The door will automatically lock itself within 10~99 seconds when this function
is programmed.
15-2
This function is not preset at the beginning; it can be set if needed.
15-3
The preset delay-time is 30 seconds; you can adjust the period you want.
15-4
Please repeat the same programming steps to cancel Auto-Locking function
when needed.
15-5
The system will alarm twice if
the latch bolt gets stuck or cannot extend/retract
completely.
You need to enter a valid User Code to unlock the door and re-lock it.
The auto-locking function will be restored then.
16.Toggle Mute On/Off
16-1 You will hear beep sounds when pressing keypad, programming or operating
errors. It can be turned off if needed.
16-2 LED Illumination is still functioning when it's in mute. As there will be no any
warning alarm, we suggest not to mute the beeper if it's not necessary.
16-3 Motor operating sound cannot be muted.
