3
4
5. Install Keypad Assembly
a. Make sure the latch bolt is retracted.
b. Please refer to the diagram below for Cylinder Installation.
Place deadbolt against keypad with tailpiece in horizontal
position inserted through hub of the latch.
c. Pass the IC wire under the latch to the interior side of the door.
Cylinder
IC wire
a
b
c
6. Install Inside Mounting Plate
Pass the IC wire through the wire hole of
the mounting plate.
Fix the mounting plate with screws.
If outside lock assembly is lopsided, please
loosen the screws to adjust it's position and
tighten the screws again.
7. Identify Door Handing
Mounting Plate
Screws
IC wire
Face the door from outside, the door is left handed if the hinge is on the
left-hand side of the door, whereas the door is right handed if the hinge
is on the right-hand side of the door.
Interior
Exterior
Door
Hinge
(Left Handed)
(Right Handed)
8. Adjusting Turn Piece
Turn the turn piece to left for 45 degrees
for a right-handed door.
Turn the turn piece to right for 45 degrees
for a left handed door.
Turn Piece
(For Right Handed door)
(For Left Handed door)
9. Install receiver module
a. Remove the battery cover
(push it up and pull it out).
b. Connect the IC wire and ensure the tailpiece
is engaged with turn piece, then attach
receiver module to the door with screws.
Use wood screws for a wooden door.
c. Insert 4 (AA) 1.5V alkaline batteries and
put the battery cover back to the receiver
module.
Wood Screws
Screws
Battery
Cover
a
b
c
