Audio alarm fails to
clear on start up or
while opera�ng, unit
displays FP.
If the system has a
factory installed freeze
sensor, then the
microprocessor has
detected freezing on the
evaporator coil.
Check for freezing on the
evaporator coil and turn the
system off to thaw.
Call
1-800-KWIKOOL
if your system lacks
a freeze sensor.
System is ON and
display is showing ON
but unit is not supplying
condi�oned air.
F or C is flashing.
System is in �me out.
One of three things.
Either control is above
room temp; adjusted out
of opera�ng parameters,
or not in the correct
opera�onal MODE.
Wait 2 minutes, review
System Opera�ons guide.
Unit Displays LP, Audio
alarm is sounding
during start up or while
opera�ng.
Microprocessor board
has detected low
pressure. This alarm
might cycle on and off.
Check air filter and replace if
dirty. Make sure nothing is
blocking the filter inlet. Check
for icing on coil. Resets
automa�cally when fault
condi�on is corrected.
System is ON and flashing
F or C. The microproces-
sor resets the �me delay
when the compressor
a�empts to start.
Microprocessor board
detects voltage drop below
opera�ng parameters.
Confirm the integrity of your
power source, by inspec�ng
size and length of the power
extension cable. Be sure to
have a dedicated circuit.
System trips breaker
on start up
Incoming power is incorrect,
breaker is undersized or
faulty, and or power cable is
too long and or undersized.
Verify the circuit and power
cable is within the systems
specifica�ons, consult with
your electrician or
Call 1-800-KWIKOOL
.
System Cools, however,
the Condenser Discharge
Air Exhaust Fan is Revving,
and/or the Condenser
Discharge Fan is Intermit-
tent.
This is the normal opera�ng
condi�on and especially
when opera�ng in low
temperatures.
No ac�on is required.
FAULT
CAUSE
SOLUTION
32
Summary of Contents for BioKool KBIO1411
Page 2: ...FAMILY OF PRODUCTS...
