Level Best Operation Guide
Page 6
Troubleshooting
1. Panel does not function (buttons and lights do not work/system does not respond.)
• Ignition needs to be on with engine running
• Transmission needs to be in park and parking brake applied.
2. Red indicator light will not go out when legs are retracted.
• Reed switch(es) not grounded or reed switch is defective.
3. The action of one cylinder will not operate in one direction (i.e., it will go down,
but not up, or vice versa).
• Hydraulic hoses and/or wiring connections are crossed
• Valve not operating.
4. Jacks won‘t extend after they had been working previously.
• Directional valve is not shifting positions - possibly due to foreign object
obstructing the valve itself, or the solenoid is not working properly.
5. Pump continues to run after switch is released.
• Pump motor solenoid is stuck - tap solenoid to unstick it or replace the solenoid.
6. To retract jacks with a control failure, see
Control Panel Jumper Instructions
on Page 7.
This list represents a cross section of some possible problems and the corresponding
solutions. After reviewing the manual, if you still have problems or questions, please
contact the Kwikee Service Department at 1-800-736-9961.
LED 7 green.
• Jacks retracted fully.
LED 7 red. Audible beep for approximately 8 seconds.
• Jacks deployed.
LED 6 green.
• Unit turned ‘on’.
LED 6 flashes.
• Park brake not set.
LEDs 1 and 2 flash.
• Level sensor in warm-up cycle.
LED 5 green and audible beep.
• Auto level sequence completed satisfactorily.
Standard Operating Codes
Alternating LEDs 1 and 2 ‘on’, then 3 and 4 ‘on’ etc.
• Coach tilted too far front to back to level.
Alternating LEDs 1 and 3 ‘on’, then 2 and 4 ‘on’ etc.
• Coach tilted too far side to side level.
LED 5 flashes red.
• Jacks are out of stroke.
LED 5 flashes green/red.
• Lost communication with Auto Level Sensor.
Auto Level Error Codes
LED Positions
