Level Best Operation Guide
Page 4
1.
Start the chassis engine and turn the control panel power switch on. If any levelers are
extended, the control panel will emit a warning beep and the red "ALL UP" LED will light up
and flash.
2.
To retract all levelers simultaneously, press the "ALL UP" switch. To retract each leveler
individually, press and hold the "UP" side of the respective leg switch. Using the "ALL UP"
switch is the recommended method of retracting the levelers to assure even retraction at all
four leveler locations and eliminate the possibility of twisting the chassis frame.
3. When all leveler legs retract to the travel position, the red "ALL UP" LED will turn green,
and the pump will shut off. You can now turn off the power switch and the vehicle is ready to
travel.
Retracting the Levelers
Observing the precautions set forth on the previous pages of this manual, you are now ready
to begin leveling your motor home. With the vehicle engine running, place the transmission in
park and set the parking brake. Securely block the wheels using wheel chocks.
Locate the "ON/OFF" button on the upper left of the control panel. Momentarily depress this
switch to activate the leveling system. The LED will light up and be a steady green indicating
that the system is ready. If the LED lights up and is flashing, it is an indication that the park-
ing brake is not completely engaged or the transmission is not in park.
Reference you’re leveling tool to determine which corner of the motor home is lowest. Using
one of the "BI-LEVEL" switches which represent the front and rear of the motor home. Use
the switch that corresponds to the low end of the motor home. Depress and hold the switch
to raise the sides of the motor home until level. Now find and depress the "BI-LEVEL" switch
which represents the low side of the motor home, and hold it until the front and rear of the
motor home are level.
Your motor home should now be in a level plane. If the coach has settled slighting, you
should fine-tune your position by using the individual leg leveling switches. Push the ‘’DN”
portion of the switch to raise the vehicle and the “UP” portion to lower the vehicle.
Stabilizing
NOTE: To prevent the
possibility of damaging the
levelers and/or vehicle, it is
good common sense to
confirm the retracted position
by visual inspection.
