P 5.1
SECTION V
Parts Identification
WARNING: DO NOT ORDER PARTS BY ITEM NUMBER.
Be sure to order by Part Number and Description. Please
list the Serial Number of the machine for which the parts
are being ordered.
PARTS ORDERING PROCEDURES
IMPORTANT:
The 1082J8S Stainless Bag Tensioner is available in right and left hand models.
ALL ILLUSTRA-
TIONS DEPICTED IN THIS MANUAL ARE CONFIGURED TO A RIGHT HAND MODEL BAG TENSIONER.
Parts
lists include part numbers for both right and left hand models when applicable. Determine the hand of the machine
so as to insure that the correct parts are ordered. Information is contained in the front parts section of the closer
manual to establish if your machine is either right or left hand.
When ordering parts
ALWAYS:
1.
Specify on the order the
TYPE, MODEL
, and
SERIAL NUMBER
of the machine for which parts are being
ordered. This information will be found on the machine’s nameplate, and;
2.
Do NOT order by item number. Order by PART, or KIT NUMBER.
There is an option for ordering individual replacement PARTS, or for ordering replacement “KITS”. A KIT is an
option for related PARTS combined under one number. These KITS provide three functions:
1.
To combine various PARTS that make up a machine model.
2.
To provide options to the basic machine (e.g. UPPER FENCE).
3.
To facilitate ordering and stocking of spare parts (e.g. apare parts page in the Appendix).
To order individual PARTS, be sure to observe the following procedure:
A. Identify the desired PART(S) by referring to the assembly illustrations (pages 5.2 - 5.11). Each PART is
assigned an “Item Number” on the illustration.
DO NOT ORDER BY ITEM NUMBER.
B. Refer to the parts list. Locate the pertinent item number in the left-hand column. Opposite the item
number is the part number and description to be listed in the order.
C. Specify on the order the TYPE, MODEL, and SERIAL NUMBER of the machine for which parts are being
ordered. This information will be found on the machine nameplate.
As an example - on Page 5.3, item 1 is the KNOB - UPPER BRUSH MOUNT ADJUST. When ordering the
replacement part(s) use the PART NUMBER AND DESCRIPTION. Using the machine description located on
the nameplate, the order should specify;
“One Part Number 08-000566, KNOB - UPPER BRUSH MOUNT ADJUST
for the Bag Tensioner Type 1082J8S Model MR, Serial Number 1001"
J8S 06 04
