P 4.2
SECTION IV
Adjustments
B. ADJUST THE BRUSH DRIVE CHAIN(S)
Figure 4.
1.
Loosen the 10-32 socket head screws on
either end of the shaft cap.
2.
Loosen the socket head screws at the discharge
end of the brush shaft.
3.
Place fingers on the brush assembly as detailed
in figure 3.1.
4.
Apply enough pressure to take up slack in the
drive chain.
5.
Tighten the mounting screw.
6.
Check the location of the of the screw in the slot
and compare it to the other mounting screw in
the other side of the brush shaft. Adjust if
needed to keep the brushes aligned.
Figure 4.3
J8S 06 04
