EN
Instruction Manual
Hydropneumatic tool for rivet nuts from M3 to M10
with stroke and pressure adjustment
FASTSETM10
www.kvt-fastening.ch
31
P 1
MOTOR
SCREWING
When the rotating pin (
6
) is broken and you replace it, it may happen that the motor rotates continuously,
which means that the shaft (
13
) is too long; in this case it will have to be shortened by a few tenths to
obtain the closure of the ball (
14
). When the air is on, the shaft shall have no end float.
Unlike the situation above, the shaft is too short and it has to be replaced with a new one, fitting it without
end float, with the air on, in order to obtain the closure of the ball (
14
).
6.2 -
REPLACEMENT OF STANDARD KIT WITH HIGH RESISTANCE SPECIAL ONE, FOR M8 ONLY
WITH FIXED RING NUT:
REPLACE TOOTHED RING NUT (1) WITH THE FIXED ONE (2) + (3)(see para 3.1.2)
(1)
(2)
1,5mm
Remove the sleeve
Assemble the sleeve (
2
) and the ring nut (
3
)
(3)
