KVH Industries TracVision G4, Technical Manual

Page: 67 / 155

Main Menu
Pressing the center key will cycle the Main Menu through the
available functions as follows:
54-0147
64
TracVision G4 Technical Manual
Setup display type?
Enter Next Return
Magnetic Heading
###.#°
Proceed to Section 3.3,
"Setup Display Mode"
(set data displayed on the LCD
during normal operation)
Setup data outputs?
Yes Next Return
Setup configuration?
Yes Next Return
Select Installed Satellite A Select Installed Satellite B
Proceed to Section 3.4,
"Set Data Outputs Mode"
(set type and format
of data outputs)
Proceed to Section 3.5,
"Set Configuration Mode"
(set heading reference source,
enter gyro offsets, reset to factory
defaults, and turn TV comm on/off)
Get Antenna status?
Enter Next Return
Control antenna?
Enter Next Return
These menus will not
appear if GyroTrac is
configured to operate as a
stand-alone system (e.g.,
COMM OFF).
Proceed to Section 3.7,
"Antenna Status Mode"
(check status and version of
antenna, get antenna serial #, get
signal level & threshold, display skew
angle, and measure bit error rate)
Proceed to Section 3.8,
"Control Antenna Mode"
(adjust antenna azimuth and
elevation manually, restart system,
install satellite pairs, set lat/long,
select active satellite, and update
satellite frequency data)
To Factory Default or
Chosen Data Display
Control Compass?
Yes Next Return
Proceed to Section 3.6,
"Control Compass Mode"
(set calibration, read cal score, and
clear compass calibration)
This menu will only appear
if the heading reference is
configured as INTERNAL.
Figure 3-5
Main Menu Functions