26
54-0215 Rev. C
•
Twisted-shielded-pair should be used to connect the gyro output to the user
interface. The shield may be connected to analog ground at the gyro and signal
ground in the user’s electronic interface.
•
Due to the low-level analog voltages from the gyro, cables longer than 12" (30 cm)
to the user’s interface are not recommended without buffering.
•
As the output drivers on pins 4 and 5 in the gyro are both active devices, neither
pin should ever be tied to ground.
•
If the gyro differential output is tied into a system where another sensor utilizes a
2.5-volt reference that would be connected directly to one of the gyro outputs,
isolation is necessary.
