Maintenance
28
28
Maintenance
Replacing the
tines of the harrow
We strongly recommend that you observe the safety warnings given
in the previous pages of this manual.
Before proceeding, check that:
•
the tractor Pto is disengaged, the engine is switched off and the
key has been removed from the starter switch
•
that the tractor wheels are chocked
•
that the hydraulic linkage control has been locked to prevent the
linkage being lowered accidentally.
We recommend that you use only Kverneland original replacement
parts.
NOTE
The tines may continue to be used until they are worn down to half
their original length, at which point they should be replaced. Tines
worn down to 150 mm in length (half the original length) may only be
used at very shallow working depths.
To replace the tines, raise the machine and use suitable equipment to
prevent it from falling; to remove the old tines, follow the indications
given in the figure below.
To fit the new tines, carry out the steps illustrated in reverse order.
