Maintenance
77
Tines with blade springs
Unlock the retaining screw without removing it (E).
Completely release the blade spring using the tightening screw
(C).
Unscrew and remove the pivot screw (D) and retaining screw (E).
Replace the tine.
Tighten the pivot screw to 200 Nm (
148 ft.lbf
).
Grease the clamping screw.
Using a suitable tool (e.g. a jack), compress the blade spring
upwards.
Tighten the clamping screw until the gap between the center of the
two axes equals 50.5 cm (
20”
).
Tighten the fixing screw to 300 Nm (
221 ft.lbf
).
Once the tine has returned to the low position, check that it is tight
and does not jam at any point.
C
E
D
Summary of Contents for CLC Evo
Page 8: ...Safety 8 ...
Page 9: ...Safety 9 Folding machines ...
Page 10: ...Safety 10 ...
Page 72: ...Maintenance 72 5 00 folding chassis Double tube roller bar ...
