13
10. Cueing device adjustment
Should you find that in the ‘up’ position the cartridge is too high or too low above the record
then the cueing device can be raised or lowered. This can be done simply by using Allen key
1.5 mm:
Insert key into screw on side of arm rest.
Release screw, raise or lower device and retighten.
Rotation of cueing device can affect the drift of cartridge while travel vertically down.
The cueing device may lift slightly as the screw is retightened. Do not over-tighten as this
may cause the cueing device to stick in the ‘up’ position. Should this occur, slightly release
the screw. (Fig.9)
11. Maintenance
The bearing does not need maintenance. Clean dust from the tonearm with a dry cloth and use
a soft cloth and alcohol to remove silicone oil.
12. Transport
During transport the tube assembly must be removed from the horizontal bearing assembly.
To do this you must remove the vertical paddle. Remove vertical trough and reposition cable
on the tube assembly. Fig. 3B.
REMOVE ALL SILICONE OIL!
Return fixing foam below tower of the horizontal bearing assembly! See Fig. 14.
If you transport a turntable with tonearm, ensure that hard vibration from the car does not
transmit directly to the tonearm. Placing soft material such as rubber, foam or a thick blanket
below the turntable is helpful in filtering rough vibrations even when the platter is removed.
Fig.14. Insert fixing foam by lifting horizontal tower- see Fig. 2A
