Kustom Signals Falcon HR, Operator'S Manual

Page: 17 / 97

SECTION 3 - INSPECTION AND INSTALLATION
3.3
3.2.2 SPEEDOMETER PULSE CABLE
Installing the provided cable to the vehicle’s speed sensor
(VSS) provides a signal to the Falcon HR for Kustom
Signals patented Tru-Trak assisted patrol speed search
feature. This feature virtually eliminates the problems of
patrol shadowing and patrol combining. This signal also
allows the unit to automatically switch between moving
and stationary modes as the vehicle’s movement is sensed.
1. The speedometer pulse cable has a connector at one
end, which plugs into the mounting pod of the Falcon
HR.
2. The red wire (inner conductor) of the cable will be
connected to the patrol vehicle’s electrical speedometer
input cable using the splice connector provided. Due to
the vast amount of models, makes and years of
vehicles, we have moved access to specific vehicle
diagrams online where information can be better
maintained and distributed.
Installation details can be accessed at:
http://www.kustomsignals.com
(Products

Radar

Model

Speedometer Installation)
If your vehicle year, make and/or model is not listed or you
need hard copies, please contact Kustom’s Customer Service
Department at (800) 835-0156. If you are outside of the US and
Canada, please call (620) 431-2700.
NOTE: Only the inner conductor of the speedometer pulse
cable is used. The outer shield is not connected.
3. The speedometer interface will be set up later, in Sec.
6.4.