2. Menu Tree:
Press
*
A) Secured Access Pages
While in the Main page or Generator Hours page, a
Quick press of the
*
key brings up the Security Access
page and a default number 5000 is displayed in the
ACCESS CODE box.
Use the
p
and
q
keys to scroll to the correct access
code and press “ACCEPT” to enter that number (default
ACCESS CODE is 1234). The longer you hold down
the p or q key, the faster the scrolling of numbers. False
entry results in Main Page being displayed. Entry of
correct access code unlocks the instrument and brings
up the following menu:
B) Category:
I.ALARMS
II.SETUP
III.DETAILS
IV.ABOUT
I. ALARMS Menu:
BATT VOLTS HI
BATT VOLTS LO
OIL PRESSURE HI
OIL PRESSURE LO
ENGINE TEMP. HI
ENGINE RPM HI
<-- BACK
Alarm Ranges:
Engine RPM:
0000 - 9999 is set to 1300 (whole
numbers only)
Oil Pressure:
Low/High settable to 00 - 99 (whole
numbers only)
Engine Temp:
High settable to 100 - 250
Battery Volts:
Low/High settable to 9.0 - 33.0
II. SET UP:
ACCESS CODE
USE DEG C/BARS ( or use DEG F/PSI)
RESET MIN/MAX VALUES (see Details page)
<-- BACK
About
Down Accept
Up
Quit
ACCESS CODE
USE DEG C/BARS
RESET MIN/MAX VALUES
SET CAN BUS SPEED
< - - BACK
-ACCESS CODE SETTING
If no key has been pressed for 60 seconds from any of
the menus or submenus, the instrument will revert to
displaying the Main Page.
The ACCESS CODE is required to access alarm
settings, and instrument setup menus. Set the ACCESS
CODE to a number from 0000 to 9999 by using the
p
and
q
keys then press the + key to accept. The factory
default is set to 1234. For S/W: 2.1 or higher default is
set to 4321.
If the ACCESS CODE is ever forgotten, the instrument
can be reset back to factory default. Reset to “Factory
Defaults” by pressing and holding the
p
and
q
keys
while applying DC power. Answer “Yes” by pressing key
labeled “Yes”. This will reset pasword to 1234. Caution:
Resetting to factory default will reset all alarm settings as
well.
-SET CAN BUS SPEED
Serial #’s starting with the letter ‘B’ can be adjusted to
various Can Bus Bit Rates: 50,125,250,500,1000 K Bits.
Units are factory set to 500K.
Alarms
Set Up
Details
About
Setup
Details
About
Down Accept
Up
Quit
Alarms
Set Up
Details
About
Setup
Details
About
Down Accept
Up
Quit
Batt. Volts HI
Batt. Volts LO
Oil Pressure HI
Oil Pressure LO
Engine TEMP HI
<-- BACK
Engine RPM HI
1
16.0
CHANGE
VALUE
DC VOLTS
About
Down Accept
Up
Quit
ACCESS CODE
USE DEG C/BARS
SET CAN BUS SPEED
< - - BACK
1
0500
CHANGE
VALUE
BIT RATE KB/S
RESET MIN/MAX VALUES
170 Cherry Avenue
West Sayville, NY 11796
www.kussmaul.com
Ph: 800-346-0857
Fax: 631-567-5826
3
