I.
WIRING
The VOTT comes with a 33 inch length six conductor
cable with a Deutsch Connector #DT04_ 6P attached.
The VOTT will operate from 9.5 to 33.0 VDC input. It
displays data via J1939 CAN Bus.
Meter Deutsch connector pin ID is
.
II.
MOUNTING
The VOTT requires a 2-1/8” diameter round hole for
mounting. The meter comes with a aluminum U shaped
mounting bracket and #8-32 nuts and lock washers to
secure bracket.
See Figure 1. (FINGER TIGHTEN ONLY, DO NOT USE
TOOLS)
III.
MENU NAVIGATION
1. Main Page
When the instrument is powered up it displays the “Main”
page. The “Main” page displays: ENGINE RPM,OIL PSI,
ENGINE TEMP F (OR C) and BATT VOLTS. Values are
displayed in GREEN if within acceptable alarm set limits or
RED if out of limits condition exists
.
From MAIN PAGE display:
• Pressing the
p
key for ½ second (longer than a quick
press but shorter than 2 seconds) will cause a white
ALARM bell symbol to be displayed and enable the
alarms.
• Pressing the
q
key for ½ second (longer than a quick
press but shorter than 2 seconds) will disable the
alarms and remove the white alarm bell symbol.
• Press the “+” key momentarily while an alarm
condition exists will silence the audible and external
alarm as indicating by Red “X”
• Pressing the
+
key for ½ second (longer than a quick
press but shorter than 2 seconds) will increment the
backlight level through four different intensities
.
ENGINE RPM
ENGINE TEMP F
OIL PSI
BATT VOLTS
2971
53
125
13.8
Pin
Signal
Wire Color
1
+9.5- 33.0 VDC
Red
2
Power/Signal Ground
Black
3
J1939+
Yellow
4
J1939 -
Green
5
External buzzer 12
VDC alarm output
+
White
6
External buzzer 12
VDC alarm output
-
Blue
2-1/8” (55mm)
Hole
Spacing Nut (x2)
Bulkhead Gasket - Pre-Installed on
Rear of Panel
Clamping Nut (x2)
Lock
Washer (x2)
Mounting
Bracket
ENGINE RPM
ENGINE TEMP F
OIL PSI
BATT VOLTS
2971
53
125
13.8
ENGINE RPM
ENGINE TEMP F
OIL PSI
BATT VOLTS
2971
53
125
13.8
x
170 Cherry Avenue
West Sayville, NY 11796
www.kussmaul.com
Ph: 800-346-0857
Fax: 631-567-5826
2
