31
KÜSCHALL
COMPACT
attract
© Küschall AG, Switzerland | 2016-01
Service Manual
REAR WHEELS
Wheel camber
A wheel camber of either 0° or 3° is possible.
Changing the wheel camber
Difficulty:
Tools:
18
1
9,
2
2
The wheel camber is changed by replacing the adapter sleeve:
1
Remove adapter sleeves
B
or
C
on both sides.
2
Insert new adapter sleeves
C
and
B
on both sides at the required,
identical position in the vertical brace
A
and fasten securely with
nut
D
.
Ensuring the rear wheels are parallel
Difficulty:
Tools:
18
1
9,
2
2
Loosen nuts
D
of adapter sleeves
C
on both sides.
At the height of the center of the axle, measure the distance
between the rear wheels at the front and back (x, y).
Distance, back > distance,
front
Turn adapter sleeve towards rear
(viewed from above)
Distance, front > distance,
back
Turn adapter sleeve towards front
(viewed from above)
In accordance with the table, turn the adapter sleeves so that the
distance between the rear wheels is the same at the front and the
back (x = y) – measured at the height of the center of the axle.
i
At the same time, the distance between the individual wheels
and the relevant side frame can be checked for conformity and
adjusted if necessary.
Retighten nuts
D
of adapter sleeves
C
on both sides.
Adjusting the removable axle
Difficulty:
Tools:
1
1,
1
9
Remove the rear wheel.
Hold the end of the removable axle
B
using the open-end
spanner.
Adjust the length L of the removable axle by turning the nut
A
.
The length is correctly adjusted if the removable axle engages
correctly when fixing the wheel and wheel has just minimal
clearance.
i
The wheels must be exchanged (left to right side and vice versa)
after adjusting both removable axles. The adjustment must now
be checked or carried out again to ensure the wheels can be
switched.
0˚
3˚
D
à
33 Nm
