Kusam-meco M3500, Manual

Page: 81 / 164

76 76 76 76
When the display is turned off, an “OFF” will be lit at right side of the
display screen as shown in Figure 4-6 . This doesn't mean the display is
POWER-OFF, but only that the measurement readings will not be sent to
the display. This option will accelerate the measurement process
because there is no I/O delay. But turning off the display will not affect
the messages displayed from the RECALL, MENU and CONFIG
operations.
You can send a message through the remote interface from their PC
terminal to the lower row display and will substitute the original display.
Figure 4-6
Default
The display default is “ON”. The “On/Off” selection made by you is stored
in a volatile memory and the default (ON) will be restored when the
meter is power-off.
How to control the display
You can control the display through the front panel operation or through
the remote interface operation. The remote interface operation has
higher priority over the front panel operation.
Front Panel Operation
Do the procedure SHIFT + CONFIG buttons > SYSTEM > ENTER >
DISPLAY > ENTER > ON/OFF > ENTER to enable/disable the display.
Remote Interface Operation
The following commands show how to control the display as well as how
to send a message to the display:
DISPlay {OFF|ON}
(
turns off or turns on the display
)