30
the
〔
〕
, select continuity measurement function. LCD displays continuity symbol “
”on the upper part.
Connecting the devices as shown in Figure 9,the beeper sounds continuously if the loop circuit resistance
under measurement is less than 50Ω,and LCD shows the present measured resistance value.
8.7
8.7
8.7
8.7
Measurement-filtering
Measurement-filtering
Measurement-filtering
Measurement-filtering
function
function
function
function
Selecting measurement-filtering function stabilizes the measured value displayed on LCD.
In DCV, OHM, TC, RTD function, pressing the
〔
AVG
AVG
AVG
AVG
〕
key causes calculation of the average of the samples.
LCD shows the “AVG” symbol. Repressing the
〔
AVG
AVG
AVG
AVG
〕
key cancels the calculation and the “AVG” symbol
disappears.
8.8
8.8
8.8
8.8
Measured
Measured
Measured
Measured
Value
Value
Value
Value
holding
holding
holding
holding
function
function
function
function
Apart from the continuity measurement functions, the reading-hold function can also be used to preserve the
current measured value on the main districts part of LCD, which consequently doesn’t refresh the measured
value.
Pressing the
〔
HOLD
HOLD
HOLD
HOLD
〕
key selects reading-hold mode, and LCD displays “HOLD” symbol. To cancel the
selection, press the
〔
HOLD
HOLD
HOLD
HOLD
〕
key again and the “HOLD” symbol disappears.
9
9
9
9
Environmental
Environmental
Environmental
Environmental
Temperature
Temperature
Temperature
Temperature
Test
Test
Test
Test
The calibrator can measure the surrounding environmental temperature. After turning on the calibrator, to
observe the surrounding environment, pressing the
〔
T.DISP
T.DISP
T.DISP
T.DISP
〕
key causes LCD displays the room temperature
value and the unit in the assistance districts part of the LCD. Repressing the
〔
T.DISP
T.DISP
T.DISP
T.DISP
〕
key cancels the room
temperature value.
Summary of Contents for KM-CAL-906
