WARNINGS
Read Before Operating
Th
e Neo’s User’s Guide must be carefully read by
all individuals who have or will have the
responsibility of using, maintaining or servicing this
product. The product will perform as designed only
if it is used, maintained and serviced in accordance
with the manufacturer’s instructions.
Caution
⚫
Change battery only in area known to be
non-hazardous.
⚫
Use
only
mPower
’s battery PN:
12.02.02.0017 and 12.02.02.0019 .
Attention:
⚫
Changez la batterie uniquement dans
une zone connue pour être non
dangereuse.
⚫
Utiliser uniquement la batterie mPower
PN: 12.02.02.0017, 12.02.02.0019.
1
Warning
⚫
Never operate the monitor when the cover is removed.
⚫
Remove the monitor cover only in area known to be non-hazardous.
⚫
Substitution of components will impair suitability for intrinsic safety and void
warranty.
⚫
Always bump test with a known concentration gas to confirm the instrument is
functioning properly before use.
⚫
Before use, ensure that the ESD film on the display is not damaged or peeling.
Avertissement
⚫
N'utilisez jamais le moniteur lorsque le couvercle est enlevé.
⚫
Retirer le couvercle du moniteur et la batterie uniquement dans une zone connue
comme non dangereuse.
⚫
La substitution de composants compromettra l'aptitude à la sécurité intrinsèque
et annulera la garantie.
⚫
Il est recommandé de tester avec un gaz de concentration connu pour confirmer q
ue l'instrument fonctionne correctement avant de l'utiliser.
⚫
Avant de l’utiliser, assurez
-vous que le film ESD sur l'écran n'est pas endommagé
ou épluché.
Precautions
⚫
For maximum safety, the accuracy of the instrument should be checked by
exposing it to a known concentration calibration
gas before each day’s use.
⚫
Ensure that the gas inlet is not blocked.
⚫
When replacing batteries, dispose of old ones properly.
⚫
For optimal accuracy, allow the unit to warm up for 2 minutes after the start-up
cycle is complete.
⚫
Make sure the water-trap filter is clean & replaced timely.
⚫
Remove the sensor only if absolutely necessary. Zero & span calibration are
required if the sensor is moved.
2
User Interface
Four key operation, one big LCD with LED
backlight, four red alarm LEDs, and one buzzer.
3
NEO
MP18X Series
Quick Start Guide
V1.0
LED Alarm
LCD
Left Key
(Esc/Move
Cursor Left)
Right Key
(Enter/Move
Cursor Right)
UP Key
(Confirm/
Number Increase)
Down Key
(Power/Number
Decrease)
Charge/Comm Port
Buzzer
Sensor
Gas Inlet
Water-trap Filter
mPower Electronics Inc.
3046 Scott Blvd. Santa Clara, CA 95054
www.mpowerinc.com
