Performance Features
Front Panel
3-7
Split
In Program mode, this button switches the PC1 into AutoSplit mode, and adds a new Program
below a preset split point.
In Setup mode, this button selects Zone 3 for viewing or editing.
Split Layer
In Program mode, this button switches the PC1R into AutoSplit mode, and adds a layer to the
Program below the split point.
In Setup mode, this button selects Zone 4 for viewing or editing.
In any performance mode, pressing
Split
and
Split Layer
together is an editing shortcut that
displays the AutoSplit Key parameter. You can then use the Alpha Wheel to change the
AutoSplit key (or hold down the
Enter
button and play a note on the keyboards). Press
Cancel
to
return to your performance mode.
The Display Region (LCD)
The display looks quite different in each mode, so we’ll show you examples of each.
Program Mode
When you turn on your PC1, the display should look like this:
This is Program mode, where the PC1 always starts when you turn it on (to get to Program mode
from another mode, press the Program button). The top line gives you information about the
bank, while the bottom line shows the ID and name of the current program.
Setup Mode
Press the Setup button to enter Setup mode, and the display looks like this:
The setup ID usually begins with
to indicate that you’re playing a setup-although in setups
that have the AutoSplit feature turned on, the is replaced by a caret ( ). Notice that the bank
index is a letter followed by a numeral, which is the opposite of the way the bank index looks in
Program mode.