Program Edit Mode
The OUTPUT Page
7-41
Regardless of the page’s configuration, there are parameters for adjusting the pan position,
the pan mode, the pan table (if any), the crossfade control, and the crossfade sense. Layers
that use stereo keymaps, or that use layer-specific FX, have additional parameters on their
OUTPUT pages. The following page is for a mono keymap program that uses program FX:
Parameter
Range of Values
Default
Pan (or Pan 1)
± 64
0
(Pan 2)
± 64
63
Pan Mode
Fixed, +MIDI, Auto, Reverse
+MIDI
(Output Pan)
± 64
0
(Output Gain)
-96 to 48 decibels
0
(Output Pan Mode)
Fixed, +MIDI
+MIDI
Pan Table
Pan Table List
0 None
Crossfade Control
Control Source List
Off
Crossfade Sense
Normal, Reversed
Norm
Drum Remap
Off, Kurz1, Kurz2
Off
Exclusive Zone Map
Zone Map List
0 None
Pan
Use this parameter to adjust the panning of the current layer’s pre-FX signal. Negative values
pan the signal to the left channel, positive values pan to the right, and a value of zero pans to
the center. To adjust a layer’s post layer FX panning individually, go to the LYR_FX page and
set the Layer FX Mode parameter to Layer-Specific FX (see
), and then return to the OUTPUT page and adjust the Out Pan parameter.
An additional pan parameter (Pan2) appears if you have the Stereo parameter on the
KEYMAP page set to a value of On.
