EMG 457.0 / EMGF 457.0
19
Installation
Please note
F
The model EMG has an installation depth of 55 mm, thus the hob cannot
be mounted above an oven.
■
Do not use a screw driver to lever the appliance out of the opening. This
will damage the frame of appliance. When removing the appliance press it
from the bottom out of the opening.
Notes for fitting
■
The worktop must be installed absolutely horizontally and the opening must
be cleanly cut.
■
The distances of the
opening to the wall for
the front, the back and
the
side
have
to
correspond
to
the
dimension drawing!
A corner moulding of
solid wood may be fitted
to the worktop at the
back of the cooking zones
provided
that
the
minimum clearances are
maintained.
The distance to mounted
cupboards should be for
technical reasons at least
300 mm.
■
Cooker hoods or wall cupboards mounted above the hob must be installed
with a minimum distance of 650 mm to the hob.
■
No cross-bars may be in the area of the cut-out underneath. They have to
be reduced at least to the opening size of the worktop.
■
The plastic finish or the veneer of built-in kitchen furniture must have been
produced using a heat-resistant adhesive (100 °C).
■
The properly installed device
must be protected with a
cover in such a way that it is
impossible to accidentally
come into contact with the
bottom side of the hob.
This cover must only be able
to be removed with the aid of
tools and must be attached at
a minimum distance of 20 mm from the bottom of the hob, so that the
power supply cable
k
does not touch the bottom of the hob.
■
Minimum distance between the edge of the hob and neighbouring walls:
40 mm.
We recommend to seal the cut sections of the worktop for built-in sinks and
oven hobs with a water-repellent protection paint.
Each time the appliance is removed from the worktop, replace the seals.
=
The hob must under no circumstances be sealed with silicone
sealant!
This would mean that it will be impossible to remove the hob at a later
date without damaging it.
Installing several hobs
■
When installing several hobs side by side please observe the minimum
distances between the worktop openings as shown in the drawings:
Top view
Detail
Hob
Worktop