24
Maintenance and care
GB
Cleaning the metal grease filters
Disconnect the hood from the mains or switch off
the fuse!
Make sure that the grid is not damaged when you
clean the metal grease filter. Frequent cleaning may cause
the colour of the metal to change; this will not affect the
functioning of the filter.
Removing / installing metal grease filter (a)
The metal grease filter is located behind the metal screen and
can only be accessed when the hood is open.
• To remove the metal grease filter, disengage it on the bar rail
handle and remove it from its installation frame.
• Proceed in reverse order to replace the filter.
Removing / installing metal grease filters (b)
The two metal grease filters (b) are located on the left and right
inside the canopy.
• To remove the metal grease filter, first of all hold the back pin
and guide it along the side past the hinge. Then remove the
metal grease filter.
• To install the filter, proceed in reverse order, i.e. first of all
insert it in the frame at the front and then guide it along the
side next to the hinge. Finally press the metal grease filter
securely into the frame.
Cleaning by hand
• Soak the metal filter well in hot water with a detergent and then
rinse it off with hot water. Repeat the procedure if necessary,
depending on how greasy it is.
Rinsing in a dishwasher
• Lay the metal grease filter down flat in the dishwasher so that it
can be optimally cleaned. An intensive programme, at 65°C if
possible, should be selected in order to fully remove deposits
of fat.
Restore the mains power supply.
Replacing the charcoal filters
(recirculation air operation only)
The charcoal filter is located directly
behind the metal grease filter. The
metal grease filter will need to be
removed in order to replace the
charcoal filter.
• Put the charcoal filter onto the
inside of the metal grease filter.
• Clamp the fastening clamp on the
one side (1).
Then bend the two middle rods
slightly by hand (2) and clamp
them on the other side (3).
Also clamp the two individual rods
(4).
Proceed in reverse order to remove.
Cancelling the saturation display
(LEDs 1 and 4)
(metal grease filter)
After approx. 40 hours of operation LEDs 1 and 4 will blink
alternately for a few seconds when the hood is switched on.
The metal grease filter needs to be cleaned.
Pressing the
Minus button
and
the
Plus button
simultaneously will clear the counter of the saturation display.
Cancelling the saturation display
(LEDs 2 and 3)
Charcoal filter (only present for recirculation air
operation)
After approx. 230 hours of operation LEDs 2 and 3 will blink
alternately for a few seconds when the hood is switched on.
The charcoal filter (recirculation air operation only) needs to be
replaced.
This saturation display is not significant for the
extraction mode.
Pressing the
Minus button
and
the
Plus button
simultaneously will clear the counter of the saturation display.
Metal grease filters (b)
Metal grease filter (a)
Pin
Hinge
blink alternately
blink alternately
