Maintenance and care
GB
23
Opening the hood
Disconnect the hood from the mains or switch off
the fuse!
Opening the metal screen
•
Press
in the middle of the metal screen, around 30 mm from
the front edge. The lock is released (soft
CLICK
).
Magnets will keep the metal screen in a horizontal position.
• To open put your hand into the edge suction from the side and
gently pull the metal screen so that it swings open.
Closing the metal screen
• Swing the metal screen upwards until the magnets hold it in a
horizontal position.
• Then press onto the same point used for removing the metal
screen so that the lock engages again (soft
CLICK
).
To ensure that the metal screen has engaged properly, put
your hand into the edge suction from the side and pull gently;
the metal screen must remain at the top.
Removing the metal screen
The metal screen can be removed to clean it. It must hang
downwards to remove it; the hood is open.
Caution – it could fall onto the hob, so please hold it firmly!
Protect the hob located below the hood with a thick blanket!
• To remove the metal screen, hold it and press the bolt on the
bearing inwards; this will release the metal screen on one side.
It can then easily be removed on the other side.
• Proceed in reverse order to replace the metal screen.
Cleaning the inside of the hood
Pull out the power plug or disconnect the fuse!
The metal screen must be removed for cleaning pur-
poses!
Deposits on easily accessible areas on the inside of the hood can
be wiped away carefully with a damp cloth and some detergent.
Please always work carefully as there is a risk of sharp
edges causing injury.
Clean the outer surface of the motor as well.
Ensure that no moisture gets into electrical parts.
Metal screen
press bolt
