GEH 6300.0
33
Installing the hob
– Attach the separate fume duct on the rear of the worktop recess.
– Insert the support frame and fasten with six screws 4.2 x 16 mm.
– Position the hob loosely.
– Raise the burner with the tool provided, position and screw on with three
screws 4.2 x 16 mm and washers in the holes with the thread collar visible.
– Then align the hob and fasten to the appliance with screws 4.2 x 32 mm
and washers through the remaining free hole at each burner location.
Assembling the burners
– Assemble the burner:
Place the burner cover and
attachment carefully in the
correct position.
– Turn the cover to bring into
position.
Checking the supply lines
Power supply
■
Check the installation of the connection cable. It must not be tightly wedged
in, pass across the cooker or be located at a ventilation channel.
Gas supply:
■
Check that all joints are tight and secure. The hoses must be installed in
such a way that they are at a safe distance from hot surfaces.
The hoses must not be tightly wedged in!
Checking the ring burners
– Ignite the burner and check that it is burning steadily.
– The flame should be steady.
[
Check whether the flames keep burning at low setting if doors / drawers
in adjacent furniture are opened / closed. If they go out, the rear of the
installation must be sealed due to poor ventilation. A solution to this
problem can be requested of Küppersbusch Customer Service.
Checking the oven burner
– Ignite the burner and check
that it is burning steadily.
– Heat the oven at the highest
temperature level for at least
10 minutes and then turn it
down to the lowest
temperature level. The burner
should burn with a small, but
steady flame.
Check air adjustment using the
table below if necessary and
then re-set.
The flames should burn
steadily, but not as strongly as those of the ring burners.
Guidelines for the air setting
Natural gas H, E, E+
3.0 mm
Natural gas L, LL
1.0 mm
Liquefied petroleum gas 50 mbar
2.5 mm
Liquefied petroleum gas 30/37 mbar
3.0 mm
Cover
Attachment