Kuppersbusch EKE 6542.0, Service Manual

Page: 16 / 29

16 H1-68-02
For internal use only
7. The menu
Generally the slider will currently only operate for individual menu steps. This means that after each
change the key will need to be pressed again to make another setting.
When the menu key is pressed the time display will show F1 . Pressing the plus or minus zones of the
timer slider will enable switching between F1 , F2 and F4 (F3 is skipped if no of no pan recognition
function has been installed). The respective current setting will appear in the power setting displays
(possibly with a code in front). For
F4 four zeros will appear in the power setting displays. The
corresponding plus or minus zone of the respective slider is used to enter the code for enabling the code-
protected menu items (1147). Touching the menu key lightly will confirm the entry.
If the code has been entered correctly, the current setting of the demonstration mode will appear in the
power setting displays. If the code is incorrect the code number will be deleted and four zeros will be
shown again.
7.1 Menu items and their significance
If the OFF key in the menu is pressed when the hob is switched on, the menu will be exited without any
storing and the hob will be switched off. Timeout (30 seconds) can be awaited to leave the menu without
storing settings and without the hob being switched off.
Menu item Code Settings
F1 (safety cut out) S 1. Normal cut-out after the maximum operation
time
2. Reminder function 1 (after 20 minutes an alarm
buzzer will sound ever 10 minutes until it is
acknowledged)
3. Reminder function 2 (after 20 minutes an alarm
buzzer will sound ever 10 minutes until it is
acknowledged) If no acknowledgement has fol-
lowed after 5 minutes -> switch off the hob)
F2 (display brightness)
Key beep volume, set with the
tone pitch, for 5-zone hobs only
h
L
1…9 1 = deep, 9 = high
1…8 1 = soft, low frequency
8 = loud, high frequency
F3 (pan recognition sensor
deactivated) (only for hobs with a
pan recognition sensor) 0: Pan recognition sensor activated
1: Pan recognition sensor deactivated
F4 (code) 0000….9999 (code: 1147)
Once the correct code has been entered
F4 (demonstration mode) d Demonstration mode deactivated
1: Demonstration mode activated (relays remain off)
F5 (type setting)
(only for 5-zone hobs) 3: 8752 (only selectable for 5-zone fronts)
4: 8852 (only selectable for 5-zone fronts)
5: 9852 (only selectable for 5-zone fronts)
F7 (calibration and pan
recognition) only for hobs with a
pan recognition sensor u 0: Do not calibrate
1: Calibrate, parameter will automatically
be switched back to 0.