H1-68-02
19
For internal use only
The pan recognition sensor can be calibrated from two operating modes.
-
After the hob has been switched on, when "OFF" is shown in the display, the pan recognition sensor
can be calibrated by pressing the key sensor (lock) for a long time. The display will then show
CALt
for 2 seconds.
Calibrated data is permanently stored in the EEPROM of the pan recognition sensor.
No items may be placed on the hob during the calibration process.
10.3
Sensor locks
The lock can be used to lock key operation and cooking level settings. Only the off key can be used to
switch the hob off.
Sensor lock means that unreasonable or impermissible keys have been operated. The hob reacts to
such improper activation with an ongoing signal after 5 seconds and complete switch-off after
10 seconds. When the sensors are locked control commands are not processed.
Reasons for the sensors to lock:
-
More than one key is pressed!
-
When a cooking zone is switched off, sensors other than the respective plus and minus zones are
pressed.
-
The plus zone is pressed when the childproof lock is activated.
-
The sensor for switching on multiple-circuit cooking zones is pressed when the childproof lock is
activated.
-
The corresponding minus zone is pressed when the childproof lock is activated and the cooking
zone is switched off.
-
When the cooking zone is switched off the key for activating the second heating circuit is pressed
(only for cooking zones with several heating circuits).
-
When a cooking zone is switched on, sensors other than the respective plus and minus zones are
pressed.
-
The childproof lock has already been activated and the key sensor is still being pressed.
-
The hob is already switched on and the on/off key i seither still being pressed or it is being pressed
again.
-
An additional heating circuit has already been activated and the corresponding circuit activation key
is still being pressed.
-
The cooking zone has already been set at level 9 and the plus zone is either still being pressed or it
is being pressed again.
-
The minus zone is not released once the cooking zone has been turned down to 0.
In general
The appliance does not automatically switch on again after a power failure.
If no cooking zone is on for 1minute, the hob will switch off completely.
Attention – ONLY AS AN EXCEPTION!
The pan recognition sensor can also be calibrated with the F7 menu. Calibration will commence
when the parameter is set at "1" and the menu key subsequently operated. The parameter
display will return to "0" in this case.
Summary of Contents for EKE 6542.0
