EEB 6450.0
27
Removing and re-fitting the oven door
Removing the oven door
– Open the oven door as far as it will
go.
– Swing the hinge locks down towards
you.
– Grasp the oven door at both sides
and lift it up until it is nearly closed.
– Gently lift the door and pull the hin-
ges forward away from the door
opening.
Refitting the oven door
– Grasp the oven door at both sides
and slide the hinges into the open-
ings on the oven. The hinge will click
into place.
– Slowly open the oven door until it is
fully open.
– Swing the hinge locks back into po-
sition.
– Close the oven door.
Removing and refitting the side racks
Removing the side racks
.
– Undo the screws.
– Take out the racks.
Refitting the side racks
– Insert the side racks and screw into
place in front.
What to do if trouble occurs...
[
Repairs must be carried out by a qualified service engineer!
But there are some problems that you can fix yourself. You should first check
that you are using the oven correctly. Repairs during the guarantee period are
chargeable, if they are caused by user error or non-observance of the following
instructions:
Replacing the oven lamp
[
Caution: risk of electric shock!
Disconnect the oven from the mains
before you open the oven lamp cover. Switch off the fuse or pull out the
mains plug!
[
Allow the appliance and the lamp to cool before changing the lamp. If
the oven has been used recently, the lamp will be hot!
Type: 25 W, 230/240 V, fitting: E14
Important:
bulbs must be heat-resistant up to 300°C!
These lamps are available from KÜPPERSBUSCH Customer service or from
your dealer.
Changing the light bulb:
– Unscrew the shelf rack.
– Carefully lever out the glass co-
ver with a screwdriver.
– Remove the faulty light bulb
and screw in the new one.
– Replace the glass cover.
Fault
Cause
Remedy
Oven cannot be switched
off.
Faulty electronic com-
ponent.
Switch off at the mains; call
Customer service.
Oven does not heat up.
Blown fuse.
Check and replace fuse.
Is the mains plug in
the wall socket?
Plug the mains plug into the
wall socket.
Temperature setting on
“000”?
Set the temperature.
Oven light no longer works.
Blown lamp.
Replace the oven lamp.
Oven door glass cracked.
Switch off the appliance; call
Customer service.
Door seal damaged.
Fit a new seal.
Strong smells from oven in
spite of ökotherm
®
catalyst.
ökotherm
®
catalyst
must be regenerated.
Regenerate the ökotherm
®
catalyst.
Strong vinegar smell during
cooking.
Sour doughs, yeast
doughs, dishes contai-
ning alcohol.
Unavoidable odours.
Fruit juice or egg white
stains on enamel parts.
Moist cake or meat
juices.
Harmless changes in the en-
amel, cannot be remedied.
The temperature display is
reading “F1” or “F2”.
Faulty temperature
sensor
Arrange for Customer service
to replace.