Kuppersberg FQ663 B, Technical Passport

Page: 8 / 28

8
TEchnical passporT English
gas hob
conical-cylindrical or cylindrical
cylindrical components,
2. Tighten connection place with the
keys so that the pipes will be in proper
position,
3. Attach C coupling to the main gas
source by using hard copper pipe or
flexible steel pipe.
WARNING; Final Check whether
any leakage exists at the pipes with a
solution with a soap, and do not ever
use flame.
6.5. ADJUSTMENT OF HOB
PER GAS TYPES
These instructions are prepared for
specialist personnel having required
competence, the installation of the
equipment should be suitable as per
the applicable standards.
Â
All gas related works should be
conducted when the electric connection
was cut.
defined in the user’s manual. Conduct
the works with a plain tip screwdriver
at a position to see valve setting screw
by removing the switches of the hob
and rubber seals. In order to set the
low flame level, turn the gas setting
screw on the valve to have minimum
gas setting flow. Do this setting after
installing the burner component of the
burner, burning the burner and bringing
the switch setting to minimum.
Flow setting screw should be
tightened in LPG conversions as it
should be released for conversion from
LPG to natural gas.
After realization of the hob,
complete the conversion transaction
by connecting the rubber seals and
switched in the same order.
These instructions should be
used by an authorized service. The
products should be installed as per
the regulations in force and in proper
manner. Before conducting any
transaction the electrical connections
of the hob should be cut by no means.
The type label on the hob indicates
the gas type planned to be used with
the unit.
6.6. STARTING THE APPLIANCE
FIRING OF BURNER
If your hob does not have built in
lighter or during black out place the
naked flame over the burner and push
the switch to bring it to the desired
position with counter-clockwise
movement.
Gas adjustment should
be between maximum and minimum
In order to convert the hob, remove
the burner plates and flame circles
thereon. Replace the injectors as per
the followings, and change them with
the injectors with suitable diameters