Kuppersberg FQ663 B, Technical Passport

Page: 5 / 28

5
English TEchnical passporT
gas hob
stated under the product fit those of
your home. Call the authorized service
dealer for possible gas type changes in
future.
Â
When the unit was taken off its
packaging make sure that it is strong,
not bent and has no fault at all. In the
event of any doubt consult the dealer.
Â
Cut off the electric connection of
the unit from the main switch during
installation.
Â
In order that built in cook-
tops will operate smoothly the
measurements of the counter on which
it will be mounted and the materials
used for installation should be proper,
and the counter should be resistant
against heat.
Read the following instructions
to fix the hob on the counter:
In order to prevent insertion of the
foreign materials and liquids between
the hob and the counter attache the
adhesive band on the counter hole
without allowing any overlapping
before the installation.
Place the hob on the counter hole to
center the installation hole.
Secure the unit on the counter by
using the installation sheet and screws.
Please review the following figures
carefully so that the hob will be
installed properly.
6.2. INSTALLING THE
APPLIANCE
Check that the appliance is in a good
condition after having removed the
outer packaging and internal wrappings
from around the various loose parts.
In case of doubt, do not use the
appliance and contact qualified
personnel.
Never leave the packaging materials
(cardboard, bags, polystyrene foam,
nails, etc.) within children’s reach since
they could become potential sources of
danger.
The measurements of the opening
made in the top of the modular cabinet
and into which the hot plate will be
installed are indicated in either ( fig. 9. )
Always comply with the
measurements given for the hole into
which the appliance will be recessed.
The hot plate has a special seal
which prevents liquid from infiltrating
into the cabinet.Strictly comply with
the following instructions in order to
correctly apply this seal:
Â
Take off all the movable parts of
the hob.
Â
Cut the seal in 4 parts of the
necessary lenght to positionning it on
the 4 edges of the crystal.
Â
Overturn the hot plate and
correctly position seal «E» (fig. 11) under
the edge of the hob itself, so that the
outer side of the seal perfectly matches
the outer perimetral edge of the hob.
The ends of the strips must fit together
without overlapping.
Â
Evenly and securely fix the seal
to the hob
Â
Fit the hot plate into the hole in
the cabinet and lock it in place with the
relative screws of the fixing hooks (see
fig 12 )