27
EN
EN
27
Make sure that the LEDs are in permanent light mode and remove the camera from the pipe.
Switch the camera off via the basic device (for more detailed information read the manual
can3D
®
2018). Disconnect camera and rod (see
Dismounting
) and attach the protective cap.
Clean the camera (see
Cleaning
).
END OF WORK
TROUBLE SHOOTING
In case of malfunction the following list helps you to isolate possible causes and enables you
to fi nd a solution:
MALFUNCTION
SOLUTION
Camera not working
Check connections
Image blurred or stained
Check if the sapphire glass is clean
Please contact our service team in case of any malfunction as well as for requests for repair,
spare part orders or any further question:
Phone:
+49 (0) 9382 9727 - 710
E-Mail:
CLEANING
Seal the connector with the supplied protective cap and clean the camera under running
water.
NOTE
Property damage due to incorrect cleaning!
Incorrect cleaning may cause damage or total breakdown. Therefore:
•
Never use a high-pressure washer or similar means for cleaning
•
Seal the connectors with the supplied caps
•
Do not use abrasive, corrosive or other aggressive detergents
•
Do not clean electronic components under running water
